Wednesday, August 5, 2009
Simple Touch Switch
Here the schematic diagram:
Component part list:
Part Total Qty. Description
C1 1 10uF 16V Electrolytic Capacitor
R1, R2 2 100K 1/4 Watt Resistor
R3 1 10 Meg 1/4 Watt Resistor
U1 1 4011 CMOS NAND Gate IC
MISC 1 Board, Wire, Socket For U1
Notes:
1. The contacts an be made with just two loops of wire close together, or two squares etched close together on a PC board.
2. When activated, the output of the circuit goes high for about one second. This pulse can be used to drive a relay, transistor, other logic, etc.
3. You can vary the length of the output pulse by using a smaller or larger capacitor for C1. Advertisement:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.